Dating vintage oxford speakers, oxford speaker identification

65 Oxford speakers

  • On less popular Fender instruments, such as LapSteels, pots can be as much as two years earlier than the actual date of the instrument.
  • Smooth high end, punchy lows no farting out at all and nice upper mid range emphasis.
  • AlNiCo was the mainstay for decades because it produced a strong magnet which worked great in speakers.
  • The decade, though not directly shown by the source-date code, was easily determined because this particular amp was only made during the s.
  • That volume issue is one result of weak caps, ime.

National, Valco, Supro Amplifier Products. What I'm saying is that pot and capacitory date codes are not a reliable indicator of guitar build dates. Some guys swear by them, while others seem to feel that any newer variety newer production speaker would be an improvement. No, create an account now.

Oxford Speaker

  1. And remember, even the dates indicated by the pots aren't that exact.
  2. If so, what make and model of speaker or speakers should I consider?
  3. My question is, are these worth reconing?
  4. As you have probably noticed, there is plenty of information here to help date the brands that I am interested in.
  5. The prefix code letter identifies the type of magnet used in the speaker.
  6. Also Ceramic magnets were cheaper to make than Alnico, hence their usage in the s instead of Alnico.

Speaker Codes And What They Mean

Well I'm not one to leave you out in the informational cold, so here's something that I use quite often in dating amplifiers and electric guitars. Dude, that speaker dating seems to be right in line with the other codes in the amp, imo. If not, what would you folks recommend to get that magic vintage sparkle of yore out of that superb amp? That is, the Oxfords won't be heard. Earlier Oxfords can be excellent speakers.

These codes don't make a lot of sense, so are noted below. So guitars and amps made as late as can still have date codes from this huge stocking. Sometimes there just isn't enough information on electric instruments and amps to allow them to be properely dated. The bottom cab is the sweeter, speed dating more articulate cab. That's kinda what I suspected.

How the Source-Date Code Works. This supply lasted for over five years. Not beefing about the bump, but I wish there was a visual cue to show the zombie-osity. If so, you can check the pot or speaker for the source-date code, and determine an approximate age from that.

It is not a code that I have seen for any Oxford guitar speaker. Not a bit of harshness in these as compared to other new speakers. Jensen was a very popular maker of guitar amplifier speakers during the s and s.

Usually this isn't too difficult. Though they are one piece of the puzzle and something to consider, don't put too much faith into a pot date. Since I primarily collect amps by Fender, and guitars by Gibson, Fender, Martin, National, Epiphone, Gretsch and Rickenbacker, restore I really can't help them with these other less popular brands.

It may have been some time before the part was installed at the factory, but it still provides a good approximation of when the gear was made. Return to the Feature Index. If you can't, read the above information again! They had a Professional series, a Concert series, jocuri dating in and a Standard series.

Fender and Gibson used them, and did many other makers. Are the wires of the right era cloth insulation for older stuff? On popular Fender models, internet dating for walkers the pot date can be very close to the actual date of the instrument. What kind of speaker is this exactly?

Oxford Speaker Identification

Also where is this voice coil gap? In either case, the code works the same. Great sounding cone breakup when pushed. Are there any date codes on those speakers.

Admins, could something be programmed? To me they are very smooth. This seems silly, as we're talking about electronic parts not eggs.

Telecaster Guitar Forum

Gibson used some pots with strange codes during the s that were confusing. Looking to find a good re-coner for the job. And many people ask me to try and determine the year of their old amplifier, or to help them with the year of their older off-brand electric guitar.

Then from and later you see Fender using speakers from all the above mentioned makers. Jason, ime, those low efficiency Oxfords don't perform matched with anything except another speaker that has a very simular efficiency rating. Actually, it's not a source code but is a manufacturers code for all National, Valco, Supro products.

Manufacturer Source Codes. Dude, being Alnico, thsoe Oxfords probably pre-date the change that Oxford made to the voice coil gap. Note the different position of the markings, even on pots from the same maker.

Twelvefrets, I am not familiar with that code. Anyway, with it came the original speakers which are both dry as the desert sand and torn. You have to make that call. If you are running something like a db speaker with them, then perhaps the mix and match will work. This is a germane bump to an old thread.

Speaker Codes & Applications

Oxford Speaker Identification

Power supply capacitors and filter caps are two names for the same thing. Of course this all assumes the pot or speaker is original. Instead of a permanently magnetic magnet, electricity was used to make the magnetic field.

65 Oxford speakers

By continuing to use this site, you are consenting to our use of cookies. The only time you will hear those speakers though, is if you run the bottom cab by itself. Note the font style of the source-date code number always seems to be the same, for all speaker manufacturers. It can be stamped or marked on any product to identify the production source vendor and date of manufacturer.

Most Recent

  • Dating 24 year old virgin
  • Korean dating show jjak
  • How much money does a dating website make
  • Teenager dating service
  • Dating a scorpio sagittarius cusp
  • How to get a girl to reply on a dating website
  • Celebrity speed dating